Showing posts with label auto repair. Show all posts
Showing posts with label auto repair. Show all posts

Getting ready for winter



Is the car you drive every day ready for the cold weather to come? If your not sure, read on for a few suggestions to help you on the way . . .

Everything begins with the battery. If your battery is dead, you aren’t going anywhere. Batteries last 3-4 years in most cars, and they tend to fail without warning during extremes of hot or cold. If your battery is four years old I suggest you replace it because it’s on borrowed time. How do you know its age, you ask? Many batteries are stamped with a date code that your service technician can read. Failing that, you should keep service records, and some motorists can actually lay their hands on such things!

Well equipped shops have battery testers that can warn you of a battery’s impending demise but in my opinion it safer to just change them on a time schedule because I’ve seen batteries that tested 80% fail totally on the next subzero morning. Test technology only goes so far, I guess . . .



How are your windshield wipers and washers? You really need them in winter, so this is the time to replace marginal blades. We’ve had good luck with the new Bosch Ikon blades, which are all-rubber so they don’t freeze and jam like traditional metal-and-rubber wipers.

Washer nozzles can clog (you can clean them with strands of wire) and get bent out of aim. Fix them now, and make sure your washer reservoir is filled with the right washer solvent. Don’t know where the solvent goes? On most cars the washer reservoir is white or translucent and has a pop off lid, as shown. Most washer fluid is light blue in color.

The next item to check is your coolant, which is also called antifreeze. Early cars used water in their cooling systems. Not any more! Newer vehicles use sophisticated chemical blends to achieve the combination of cooling efficiency and corrosion reduction that today’s cars require.

Coolant absorbs chemicals from the engine, and it can become corrosive if it’s left in a car too long. That’s why most car makers suggest changing coolant every three or four years, even if you don’t drive a lot.

For many years there was only one kind of antifreeze, which was green in color. Many of today’s cars use special coolants that have additives to protect the various metals and plastics in modern engines. In our shop, we’ve learned to use BMW coolant in BMW cars, and Jaguar coolant in Jaguars. If you drive a late model import it almost surely takes special coolant. I suggest you follow the manufacturer recommendations in this area because I’ve seen the wrong coolant cause leaks, clogs, and even overheating failures.

The coolant reservoir for the engine usually has a screw-on lid and it’s filled with green coolant in older cars. In newer vehicles the coolant can be yellow, red, or dark blue. Don’t confuse those two liquids!



In the picture above I'm pointing to the washer reservoir. The coolant reservoir is to the right.

How’s your heat? We don’t pay much attention to our car’s heater during summer, but we’ll be needing heat any day now. In a modern car, a weak or inoperative heater is usually a sign of other problem, like low coolant or a stuck thermostat.

The final thing to check is your tires. Where I live we fit snow tires, and this is the time to be doing that. In other areas people use the same tires year round, but it’s important to make sure you have good tread. Remember that a tire can wear unevenly, so it looks good on the outside edge but the inside or center is totally bald. Don’t be fooled by tire trickery!

If you do have uneven wear it’s probably a sign your car needs alignment.

The staff at Robison Service are always here to answer your questions and resolve any service needs. Remember that it’s always less costly to maintain your car preventatively that to respond to breakdowns.

We are located at 347 Page Boulevard in Springfield, Massachusetts. Call 413 785 1665 or email service manager Maribeth White at mwhite@robisonservice.com

John Robison

How much for that alternator?



How much to put an alternator on my car?

I hear questions like that all the time. Rather than pick a number out of the air, I counter with a question of my own. “Why do you think you need an alternator?

There are two common reasons a motorist would ask that sort of question. The first is that someone said their car needed an alternator, and quoted a price that was shockingly high. The second possibility is that the car has a problem like a dead battery, and the owner has decided an alternator will fix it.

In the first case, there could be several reasons for the high price. The motorist may simply be out of touch with the true cost of car repair. The repair may have been quoted with a top quality alternator, when the motorist can only afford something cheap. Finally, there may be a complication to doing the job, and the garage quoted additional time and material to cover that.

All of those situations are best resolved by a customer and repair shop that collaborate to reach a solution. A price shopping motorist is not likely to obtain a good result, because there’s more to a good repair than the lowest bid.

I’m always happy to explain the reasons behind the probable cost of a repair. Do we have to take parts off for access? If so, it makes sense to service them, too, but that costs money. Do we have choices when it comes to replacement parts? Much of the time you get what you pay for, but there are times when aftermarket parts can service the purpose at lower cost.

Motorists will do much better working through those questions with one shop, where they know the person and the vehicle. Taking a quote and simply price-shopping by phone is very unlikely to get a good result because the questions that need to be answered are not strictly those of cost.

What about the motorist who just decided he needs an alternator? Some shop owners would say, the guy asked for an alternator. Sell him one! Who cares if he needs it? I’ve never really subscribed to that school of thought. If someone thinks they know what the car needs, I say, If I put the alternator on, and the car still has the same problem, how are you going to feel?

Few motorists consider that possibility, but in my experience, it’s very real. It’s amazing how many people will think it’s my fault if the car still has a problem, even though they made the diagnosis.

Once again, the best answer is to find a mechanic you can trust and discuss the problem with him rather than make an impulsive decision on your own.

So that leads to the biggest question of all: How do you find a mechanic who is capable, trustworthy, affordable, and all the other things you want? That is the subject of another post . . .

Trust in the auto service environment

Yesterday one of the blog commenters said,


I took the wife's Taurus to a local shop, because it was the middle of winter, and I didn't feel like messing with it. They told me it needed complete rear brake system, all of the way across. They, of course, would be more than happy to do it, to the tune of $800. I declined their service, dusted off my toolbox, and found that the pins in the calipers were corroded in place. $7.50 later, the rear brakes are working fine. Needless to say, I'll never take the wife's car back to that mechanic.


So, that's the issue for me. Trust. If I get the vibe that the shop is trying to make a quick buck, I'll walk out the door.


At first glance, it might seem that the local shop lost the customer’s trust because they exaggerated what was wrong with the car. I think the problem developed earlier, though. For some reason, the customer doubted the shop enough to do their own inspection, which revealed something different from what the shop said.

What prompted the inspection, if not a lack of confidence or trust?


And what could a shop do about it? Here’s my take on this particular situation, which starts with a simple explanation of how brakes work.


At each corner of the car, you have a brake assembly. In a car with disc brakes, that consists of a caliper, pads, and a rotor. The brake calipers are like clamps, whose faces hold brake pads. When you step on the brake pedal, the clamps press the pads into the sides of the brake rotor, which is like a spinning plate. That friction is how brakes stop your car.


It’s the same idea as the brake on a 10-speed bicycle, just bigger and heavier.


The pins the fellow refers to are part of the caliper assembly. When they rust in place, the caliper is no longer free to move, and it doesn’t clamp correctly. That can cause a number of problems. First, the brakes simply won’t work as well as they’re supposed to. Second, some parts will wear out early while others don’t wear at all. Third, when one wheel has a problem and the others are fine, the car will develop a tendency to dive to one side when the brakes are applied – a dangerous situation.


There is more than one way to solve this problem. The most basic solution is to hammer the rusty pins apart, clean them with sandpaper, grease them and put everything back together. That’s the solution my blog commenter chose. But that’s not the only solution.


I’d like to share some of the choices a service manager must make when advising a motorist about a simple problem like this:


First, a few technicians would do what the commenter did – free up the stuck pins and send the car on its way. In my experience, though, most good technicians would feel that wasn’t an adequate response, for a number of reasons . . .


Many of them would recommend replacement of the whole caliper assembly, reasoning that the rust will simply return and new parts will ensure a more permanent repair. There’s also the concern that visible rust on the pins may be just the tip of the iceberg. The inside of the caliper may be rusty and ready to fail, too. That’s a perfectly valid reason to recommend a caliper in this situation.


On an older car, when you replace one caliper, it often works better than the original calipers on the opposite wheel. The result: the car now pulls to one side when you apply the brakes. The answer to that is simple – replace calipers in pairs on older cars. It’s not always necessary, but it’s quite common.


When you remove a caliper for any reason, there is always the risk that one of the metal lines that connects it to the master cylinder will fail from rust and age. When that happens it may take several hours to fabricate and install a new line. That’s an example of a complication that can cause the price of a job to increase.


After deciding what to do with the caliper, the service manager has to decide what to say about the pads and the rotors. If they are in near-new condition, there is little to decide – you leave them alone. But that’s rarely the case when a car arrives with a problem the driver can feel. By then, both pads and rotors are probably worn, and the question becomes . . . how worn is too worn?


There’s a lot of leeway for interpretation at this point. A shop that works on high performance cars might recommend replacement when the pads fall below 50%. A shop that caters to older cars whose owners are on a budget might stretch that margin to 10% or even 5%. There is no absolute right or wrong – they just serve markets with differing needs and expectations.


Rotors are the same way – the carmaker provides a minimum thickness, and you measure the rotors, compare to the spec, and make a judgment call. But thickness isn’t the only criteria. There is also flatness, which is more subjective. A rotor that is just a few thousandths of an inch out of flat will make the whole car shudder when braking from high speed. That’s a big deal to on a fast highway, but it might not matter much to a city cab driver. Once again, the service manager has to know how to match his customer’s needs with his own recommendations and the car’s condition.


Can the service manager understand those issues, explain them, and help guide the motorist to a good choice? Some can. Other “service managers” have little or no training or automotive knowledge, and they simply sell the “special of the week,” something that virtually ensures mistrustful, dissatisfied customers.


In my opinion, the best way to earn a consumer’s trust is to explain the situation to them so they can make an informed decision. Someone who understands the choices may disagree with my recommendation, but they won’t think I am crooked or tricky. However, the service manager has to have a deep understanding of how automotive systems work to be able to explain anything on demand, and that’s where our system breaks down. We don’t have enough trained and articulate people out there, and that’s a bit part of the industry’s trust problem.


I think that ability is one of the things that sets Robison Service apart from many other shops.

Shopping for service when money is tight

Now that money is tight, people have started price-shopping for everything. Even car service. I’m all in favor of spending my money wisely, but choosing car service on the basis of the lowest price quote may not lead to the outcome you want.

If you want a new GE oven, price shopping makes sense. GE sells the same oven to all their dealers, so you can indeed choose on the basis of availability and price. You can even do that with cars. A brand-new Camry is a Camry, no matter what Toyota dealer it comes from.

So you may be fine choosing your new car on price, distance to the dealer, or attitude. But when your car needs service, the picture gets a lot more complicated. A recent Consumer Reports article pointed out the huge variation in price quotes for a 60,000 mile service. Their reporter called around and got very different prices from a mix of dealers and independent garages.

The implication is that you can save money by making a few phone calls. But what exactly are you getting? I’ve done similar studies and I’ve taken the time to actually ask what I’d receive for my money. One garage changed the transmission fluid, another changed spark plugs. One dealer said the axle fluid is “permanent” while the dealer across town dealer changed it. The result – no two 60,000 mile services are the same.

That discovery renders the different price quotes totally meaningless. So what’s a motorist to do? I looked in the owner’s manual for the answers. To my surprise, not one of the quotes I received exactly matched the manufacturer’s checklist, though several were close.

So who do you believe? Conventional wisdom says the manufacturer knows best, but I don’t know if that’s really true. After all, if your car lasts forever, where will that leave them? That’s why I take ideas like “permanent transmission fluid” with a grain of salt. Long experience as a service manager tells me you change the fluid, or you change the transmission. Sure, the transmission may last through several fluid changed, but what would you rather do? I’ll take three $200 services over one $3,000 transmission any day. Wouldn't you?

Of course you would - if you knew. That's where a relationship with a trustworthy advisor comes in. How to find such a person?

I’d keep that goal in mind when I listen to service providers explain what they’d do to a car at 60,000 miles. Can they explain things clearly and sensibly? You can learn a lot about someone's understanding of a topic by asking them to explain it to you. And competence is vital in this industry, and many others. I can’t tell you have many times I’ve heard comments like, "That dealer really ripped me off!” I hear those words, but I know many of the people involved, and they are not dishonest. They are, however, often inept.

Incompetence is the biggest problem facing the auto repair industry today. There is no licensing board like there is in medicine, plumbing, or the electrical trades. Anyone can buy a toolbox and call themselves a technician. You bring your car into their shop and they say, “You don’t need that, but you do need this.” How do you decide?

I suggest you ask the technician or service advisor to explain his reasons for doing something. Do they make sense? Does the service person give you a good feeling? If not, keep shopping. A good rapport with an auto service professional is more important than ever in today’s uncertain economic climate.

I’ll be back soon with more advice and thoughts.
Older Post ►
 

Copyright 2011 car care services is proudly powered by blogger.com